AMERITRON AL-1200 User Manual

Browse online or download User Manual for Audio amplifiers AMERITRON AL-1200. AMERITRON QSK-5PC Instruction Manual AMERITRON QSK

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
AMERITRON QSK-5PC Instruction
Manual
AMERITRON QSK-5PC
T/R SWITCH PC BOARD
INTRODUCTION
The Ameritron QSK-5PC is a PIN diode QSK circuit board designed
for use in Ameritron's AL-80A, AL-80B, AL-82, AL-1500 and AL-
1200 amplifiers. Ameritron can not assist customers with the
installation of the QSK-5PC in any amplifier other than these
five units. The QSK-5PC is rated to carry the full power of
these amplifiers except on SSTV, RTTY and PACKET. On these high
duty cycle modes the QSK-5PC will handle a maximum of 1000 watts
with a 5 minute on and two minute off duty cycle.
Ameritron also offers a "stand-alone" PIN diode QSK adapter
called the QSK-5. The QSK-5 is an entirely self-supporting unit
with an internal power supply. The QSK-5 is the best choice for
applications where maximum convenience and flexibility is de-
sired. The QSK-5 connects to the station equipment with standard
connectors to facilitate installation and removal.
QSK BOARD OPERATION
Keying Circuit Timing:
The timing of the transceiver keying circuit is critical with
any QSK switch. The transceiver MUST
have the proper sequencing
of RF and QSK output lines. The transceiver QSK line must pull
low BEFORE RF appears on the output connector and release AFTER
the RF envelope reaches zero to operate with any QSK switch. A
few transceivers do not meet this requirement even though they
are advertised as QSK transceivers. There is no way to
completely correct this problem without modifying the
transceiver.
One indication of improper timing is the flashing or failure of
fuse lamps LP1 and LP2. These lamps protect the transceiver
from failure of the receive diodes. Any component failure that
causes the receive diodes to conduct during the time interval
the transmit diodes are conducting will connect the amplifier's
output directly to the input. This may result in an oscillation
Page view 0
1 2 3 4 5 6 ... 13 14

Summary of Contents

Page 1

AMERITRON QSK-5PC Instruction Manual AMERITRON QSK-5PC T/R SWITCH PC BOARD INTRODUCTION The Ameritron QSK-5PC

Page 2

AMERITRON QSK-5PC AL80A/82/1200/1500 Installation QSK-5PC INSTALLATION FOR THE AL-80B 1. Remove the Amplifier&apos

Page 3

Ameritron QSK-5PC AL-80B Installation THE SMALL BYPASS CAPACITOR. Solder this wire to the ground lug of this jack. 6. T

Page 4

Ameritron QSK-5PC AL-80B Installation under the QSK plate to be sure there are at least 3/8" clearance from the recti

Page 5

Ameritron QSK-5PC AL-80B Installation 19. Solder the free end of the RG-58 cable that comes from the band switch and thro

Page 6

Ameritron QSK5-PC Parts List C19 .022 uF, 50 V, Mono 205-3220 C20 .01 uF,

Page 7

AMERITRON QSK-5PC Instruction Manual that can cause damage to the transceiver. NEVER REMOVE OR DEFEAT THESE LAMPS. They

Page 8

AMERITRON QSK-5PC Instruction Manual TRANSMIT: In TRANSMIT the circuit functions as follows: Point D is held below 2 vol

Page 9

AMERITRON QSK-5PC Instruction Manual shake." This jack will then pull low in the transmit mode. The maximum rating

Page 10

AMERITRON QSK-5PC Instruction Manual SWR SSB CW RTTY 1:1 2500 W 2000 W

Page 11

AMERITRON QSK-5PC AL80A/82/1200/1500 Installation anode connector with an insulated clip lead. NEVER DISCHARGE THE ANODE DIRECTLY TO

Page 12

AMERITRON QSK-5PC AL80A/82/1200/1500 Installation 9. Solder the new large and small coaxial cables to the relay the same way as the

Page 13

AMERITRON QSK-5PC AL80A/82/1200/1500 Installation conductor of the RG-178B/U RF cable (smallest diameter coax), that was originally c

Page 14

AMERITRON QSK-5PC AL80A/82/1200/1500 Installation 21. Solder the yellow wire supplied to the normally open termi-nal of the relay wh

Comments to this Manuals

No comments