AMERITRON AL-80B Specifications Page 13
- Page / 16
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
AL-1200
Specifications:
Input:
Circuit type: Pi-network,
slug tuned coils.
Maximum VSWR at res-
onance: 1.2:1 or less.
Minimum 2:1 VSWR
bandwidth: 20% of center
frequency. Max. drive
power permissable: 130
Watts. Typical drive for
full power output: 130 W.
Output:
Circuit type: Pi-L. 1/2
hour PEP two tone test:
1800 Watts. 30 second
PEP two tone test: 1800
Watts plus.
Power Supply:
Circuit type: Full wave
bridge, capacitor input.
No load voltage: 3600
Volts. Full load voltage:
3300 Volts. Full load cur-
rent: .8 Amp.
Regulation: 10% or better.
Transformer: 32 lb.
Hypersil
R
.
Capacitors: 26 uFd total,
computer grade.
Maximum draw at rated
output: 13 Amps. AC
Input: 240 V, 50/60 Hz.
Tubes:
Type: Eimac
R
3CX1200Z7. Continuous
dissipation: 1200 Watts.
Warm-up time: 5 sec.
Metering:
Multimeter: Reads plate
current, plate voltage,
drive/ALC, power output
(PEP Watts). Grid Meter:
Reads grid current.
ALC:
Negative going, 0-20
Volts, adjustable, phono
jack.
Efficiency CW: 65%.
*Efficiency SSB (enve-
lope crest): 62%.
MARS/WARC: Yes, set to
the nearest band.
Connectors:
Keying: Engages amplifier
when grounded, +12 VDC
open circuit and supplies
100 mA when grounded,
built-in back-pulse can-
celling diode protects the
exciter.
RF input:
SO-239, 50 Ohm input.
Power:
NEMA 5-15P, 240 Volts.
Dimensions:
18
1
/
2
Dx17Wx10H in.
Operating Weight:
77 pounds.
Shipping Weight:
Unit, 50 lb., Tube, 5 lb.,
Transformer 35 lb.
Frequency Coverage:
Domestic model: 160, 80,
40, 30, 20, 17, 15 Meters.
10/12 Meters with modifi-
cation. Must present FCC
license at time of sale to
obtain details.
Third Order IMD at
Rated Output: -34 dB at
1500 Watts output.
AL-1500
Specifications:
Input: Circuit type: Pi-
network, slug tuned coils.
Maximum VSWR at res-
onance: 1.3:1 or less.
Minimum 2:1 VSWR
bandwidth: 20% of center
frequency. Max. drive
power permissable: 100
Watts. Typical drive for
full power output: 65
Watts.
Output: Circuit type: Pi-
L. 1/2 hour continuous
carrier: 1500 Watts. 30
second continuous carri-
er: 2500 Watts plus. 1/2
hour PEP two tone test:
2500 Watts plus. 30 sec-
ond PEP two tone test:
2500 Watts plus.
Power Supply:
Circuit type: Full wave
bridge, capacitor input.
No load voltage: 3600
Volts. Full load voltage:
3300 Volts. Full load cur-
rent: 1 Amp. Regulation:
10% typical.
Transformer: 32 lb.
Hypersil
R
. Capacitors: 26
uFd total, computer grade.
Maximum draw at rated
output: 15 Amps. AC
Input: 240 V, 50/60 Hz.
Tubes:
Type: Eimac
R
3CX1500/8877.
Continuous dissipation:
1500 Watts. Warm-up
time: 180 sec.
Metering:
Multimeter: Reads plate
current, plate voltage,
drive/ALC, power output
(PEP Watts). Grid Meter:
Reads grid current.
ALC: Negative going, 0-
20 Volts, adjustable, phono
jack.
Efficiency CW: 65%.
*Efficiency SSB (enve-
lope crest): 62%.
MARS/WARC:
Yes, set to the nearest ama-
teur band.
Connectors:
Keying: Engages amplifier
when grounded, +12 VDC.
100 mA when grounded,
built-in back-pulse can-
celling diode protects the
exciter.
RF input:
SO-239, 50 Ohm input.
Power:
NEMA 6-15P, 240 Volts.
Dimensions:
18
1
/
2
Dx17Wx10H in.
Operating Weight:
77 pounds.
Shipping Weight:
Unit, 50 lb., Tube, 3 lb.,
Transformer 35 lb.
Frequency Coverage:
Domestic model: 160, 80,
40, 30, 20, 17, 15 Meters.
10/12 Meters with modifi-
cation. Must present FCC
license at time of sale to
obtain details.
Third Order IMD at
Rated Output: -36 dB.
ALS-500M
Specifications:
Frequency Coverage:
(US) 1.5 to 22 MHz con-
tinuous; (Export) 1.5-30
MHz continuous.
Input: Circuit type:
Broadband, resistor
swamped. Maximum
VSWR at resonance:
1.5:1. Bandwidth:
Broadband. Maximum
drive power permissible:
100 Watts. Typical drive
for rated output: 60
Watts.
Output: Circuit:
Broadband, low pass.
Typical SSB PEP voice
operation: 500 Watts PEP.
Typical CW operation:
400 W.
Power requirement for
amplifier:
14-16 VDC, 80A (peak).
Output devices:
Transistor, (4) 2SC2879.
Metering:
Current meter, 0-100 A.
ALC: None.
Efficiency CW: 40%.
Efficiency SSB: (envelope
crest) 45%.
MARS/WARC: Yes, con-
tinuous coverage.
Keying: Relay closure or
sinking to ground of +12
VDC at 100 mA, RCA
phono jack.
Power Supply connector:
Beau multi-contact male
chassis mount.
Power Supply Cable: 8
foot pre-wired with Beau
connector on one end;
other end with 5/8 inch
ring lugs, 10 gauge wire
(x2), in line fuse holders,
fuses included.
RF Connectors:
SO-239 for input and out-
put.
Dimensions:
15
1
/
2
Dx8
7
/
8
Wx3
3
/
4
H in.
Operating Weight:
7.5 lbs.
Shipping Weight:
12 lbs.
Third Order IMD at
rated Output:
-35 dB PEP or better.
ALS-600SPS
Switching Power Supply
Specs:
Line Input:
120 VAC/240 VAC.
Output: 50 VDC, 25
Amps, +/-14 VDC, 1 A.
Metering:
Cross-needle for volt/amp.
Output Cable:
6 foot prewired cable with
Beau multi-contact con-
nector to mate with ALS-
600 amplifier.
Dimensions:
12Dx9
1
/2Wx6H inches.
Operating Weight:
9 lbs.*
Shipping Weight:
15 lbs.*
AC Line Connector:
NEMA-5-15P.
Note:
* Total Shipping weight
for ALS-600 Amplifier and
ALS-600SPS power sup-
ply is 33 lbs., shipped
together.
ALS-600
Specifications:
Frequency Coverage:
(US) 1.5 to 22 MHz con-
tinuous; (Export) 1.5-30
MHz continuous.
Input: Circuit type:
Broadband, resistor
swamped. Maximum
VSWR at resonance:
1.5:1. Bandwidth:
Broadband. Maximum
drive power permissible:
100 Watts. Typical drive
for rated output: 100
Watts.
Output: Circuit:
Broadband, low pass.
Typical SSB PEP voice
operation: 600 Watts PEP.
Typical CW operation:
500 Watts.
Power requirement for
amplifier:
50 VDC, 25 Amps, +/-14
VDC, 1 Amp.
Output devices:
Power MOSFET (4) MRF-
150.
Metering:
Amplifier-Cross-needle
meter for VSWR, FWD,
reflected true peak indicat-
ing wattmeter.
ALC:
Negative going 12 VDC,
adjustable, RCA phono
jack. Efficiency CW:
50%. Efficiency SSB:
(envelope crest) 55%.
MARS/WARC: Yes, con-
tinuous coverage.
Keying:
Relay closure or sinking to
ground of +12 VDC at 100
mA, RCA phono jack.
Power Supply connector:
Beau multi-contact male
chassis mount.
RF Connectors:
SO-239 for input and out-
put.
Dimensions:
12Dx9
1
/
2
Wx7
1
/
8
H inches.
Operating Weight:
12.5 lbs.
Shipping Weight:
18 lbs. (amp only).
Third Order IMD at
rated Output:
-35 dB PEP or better.
ALS-600PS
Power Supply
Specifications:
Line Input:
120 VAC/240 VAC.
Output: 50 VDC, 25
Amps, +/-14 VDC, 1 Amp.
Metering:
Cross-needle for volt/amp.
Output Cable:
6 foot prewired cable with
Beau multi-contact con-
nector to mate with ALS-
600 amplifier.
Dimensions:
12Dx9
1
/
2
Wx6H inches.
Operating Weight:
32 lbs.*
Shipping Weight:
37 lbs.*
AC Line Connector:
NEMA-5-15P.
Note:
* Total Shipping weight
for ALS-600 Amplifier and
ALS-600PS power supply
is 57 lbs., shipped together.
ALS-1300
Specifications:
Frequency Coverage:
(US) 1.5 to 22 MHz con-
tinuous; (Export) 1.5-30
MHz continuous.
Input: Circuit type:
Broadband, resistor
swamped. Maximum
VSWR at resonance:
1.5:1. Bandwidth:
Broadband. Maximum
drive power permissible:
100 Watts. Typical drive
for rated output: 100
Watts.
Output: Circuit:
Broadband, low pass.
Typical SSB PEP voice
operation: 1200 Watts
PEP. Typical CW opera-
tion: 1000 Watts.
Power requirement for
amplifier:
50 VDC, 50 Amps, +/- 14
VDC, 2 Amps.
Output devices:
Power MOSFET
(8) MRF-150.
Metering:
Two Cross-Needle Meters
for VSWR, FWD, REF
true peak indicating
wattmeter, ALC, high volt-
age PA1 and PA2.
Constant current monitor
PA1 and PA2.
ALC: Negative going 12
VDC, adjustable RCA
phono jack.
Efficiency CW: 50%.
Efficiency SSB: (envelope
crest) 55%.
MARS/WARC: Yes, con-
tinuous coverage.
Keying: Relay closure or
sinking to ground of +12
VDC at 100 mA, RCA
phono jack.
Power Supply connector:
Beau multi-contact male
chassis mount.
RF Connectors:
SO-239 for input and out-
put.
Dimensions:
18Dx10Wx6
1
/
2
H inches.
Operating Weight:
22 lbs.
Shipping Weight:
27 lbs.
Third Order IMD at
rated Output:
-35 dB PEP or better.
ALS-1300SPS
Switching Power Supply
Specs:
Line Input:
120 VAC@30 Amps
220 VAC@14 Amps
Output: 50 VDC, 50
Amps, +/-14 VDC, 2 A.
Output Cable:
6 foot prewired cable with
Beau multi-contact con-
nector to mate with ALS-
1300 amplifier.
Dimensions:
9
1
/2Dx10Wx6
1
/2H inches.
Operating Weight:
15 lbs.*
Shipping Weight:
20 lbs.*
AC Line Connector:
NEMA-6-15P.
Note:
* Total Shipping weight
for ALS-1300 Amplifier
and ALS-1300SPS power
supply is 49 lbs., shipped
together.
* Exact performance measurements may vary due to the accura-
cy of test equipment and the measurement methods used.
(Prices and specifications subject to change without notice or
obligation).
http://www.ameritron.com 99
MFJCatP99_2012.qxd 4/11/2012 12:10 PM Page 1
- 2012 Amateur Radio Catalog 1
- AMERITRON 2
- 800 WATTS OUT . . 3
- Suggested 4
- Suggested Retail 5
- 1200W Output 7
- Solid State FET Amplifier 8
- ARI-500 Cables . . . $24.95 9
- Deluxe Amplifier Saver 10
- HF Mobile 11
- 2Dx10Wx6 13
- 2H inches 13
- True Legal Limit 14
- Coax Switch with 8 positions 15
- Tube Distributor . . 16
Related products and manuals for Audio amplifiers AMERITRON AL-80B
(16 pages)© 2020, manymanuals.com. All rights reserved. | 0.866 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals